StorageTek Virtual Storage Manager (VSM) System Power Calculator  (VSM5/VSM4)

The StorageTek Virtual Storage Manager System is the market-leading mainframe virtual tape solution. It improves mainframe tape drive operating efficiencies and lowers your total cost of ownership by maximizing the value of storage investments and optimizing mainframe tape drive and library resources.

The intent of the power calculator is to provide guidance for estimating the electrical and heat loads for typical operating conditions. It should not be used to calculate power or HVAC requirements. Instead, please use the appropriate site planning guide to allow for proper allowances.

Notices and Disclaimers

Note: JavaScript must be enabled to view this section of the website.

Configure your your Power Consumption for your Virtual Storage Manager now!

VSM Power Calculator
Item
Quantity
Notes
Model
Select Model Type
Number of Base Card Cages
Excludes VCF or ICE channel cards for VSM5 and VSM4e.
Base PDU and Cooling Fans
Select the number of Base PDU and Cooling Fans
Number of VCF or ICE cards
Select number of VCF or ICE cards (depending on model)
Drive Trays
JBOD Disk Trays
Select number of JBOD trays. Each tray contains 16 HDDs.
   
 
Sample Results
Item
Max Power
Total System Power   (Watts)
(estimated)
Total System BTU/HR
(estimated)
 

Notices and Disclaimers

You MUST allow electrical and cooling headroom for unforeseen circumstances, component upgrades, and increased computational loads. Please allow for worst-case power conditions. Actual power consumption will vary from the sample workload used in the power calculator. These include, but are not limited to, the factors below. Each of these factors may cause significant differences in power consumption:

  • Actual workload and its fluctuations
  • Ambient temperature
  • Cooling patterns
  • Excessive inlet temperature
  • Humidity
  • Operating systems features
  • Power management settings

The "Sample Power" results shown (if using 100% workload) represent server power consumption measurements with CPUs at 100% utilization running SPECjbb2005. HPC workloads may consume more power than the commercial workload used in this calculator. If shown for this calculator, the "Active Idle Power" results represent power consumption measurements taken from servers with operating systems booted and stabilized, yet running at minimal utilization. Sample results shown are representative of measurements taken with room temperatures below 25°C. System power can vary depending upon hardware/software configurations and environmental conditions. For precise results, actual measurements based upon the exact hardware/software/environmental conditions are recommended.

Legal Notice: This calculator is subject to change without notice and is provided "as is" without warranty of any kind, express or implied. Oracle does not make any representations regarding the use, validity, accuracy or reliability of the tool. The entire risk arising out of the use of this tool remains solely with the customer. In no event shall Oracle be liable for any direct, consequential, incidental, special, punitive or other damages, even if Oracle is negligent or has been advised of the possibility of such damages, arising from use of the tool or the information provided herein.